Stihl HL-KM Instruction Manual page 11

English
135 0 Version
The angle of th cutter bar can be
adjusted upwards in 4 stages from 0°
(straight) to 45°, and downwards in 8
stages from 0° to 90° (right angle facing
down). There are therefore 13 possible
working positions.
There is also a special transport position
for the cutter bar.
A-··To reduce the risk of injury,
Lll"~ffyoume
adjUlltme1'iioiilY
when the cutting blades are at a
standstill- engine at idle speed.
l'
The gearbox becomes hot during
Ll..l.
operation. To reduce the risk of
burn injury, do not touch the gear
housing.
10
*
To reduce the risk of injury,
Ll..l.
never touch the blades while
making adjustments.
• Pull back the sliding sleeve (1) and
use the lever (2) to adjust the joint
by one or several holes.
• Release the sliding sleeve (1) and
make sure the lock pin engages the
quadrant (3).
The sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
Transport Position
The Gutter
barcanbe
(olded (Ialagainst
the drive tube and locked in position to
save space during transportation.
h..
To reduce the risk of injury,
Lllalways shut off the engine - move
slide control to STOP or stop
switch to 0 - and fit the blade
scabbard before moving the cutter
bar to the transport position or
from the transport position to the
normal working position.
*
The gearbox becomes hot during
Ll..l.
operation. To reduce the risk of
burn injury, do not touch the gear
housing.
HL-KM
----_._--_.--
-