Acl Setup Screen; Figure 117 Acl Setup; Table 70 Acl Setup - ZyXEL Communications IES-1248-51V User Manual

compares the VLAN ID of the traffic (901) to the VID of the PVC (900), the IES
drops the packets because they do not match.

34.2 ACL Setup Screen

Use this screen to assign ACL profiles to each PVC. To open this screen, click
Advanced Application > ACL.

Figure 117 ACL Setup

The following table describes the labels in this screen.

Table 70 ACL Setup

LABEL
ACL Profile
ACL Profile Map
Port
VPI
VCI
ACL Profile
Apply
IES-1248-51V User's Guide
DESCRIPTION
Click ACL Profile to open the screen where you can set up ACL
profiles (see Section 34.3 on page
Click ACL Profile Map to open the screen where you can look at
which ACL profiles are assigned to which PVCs (see
page 267).
Use this drop-down list box to select a port to which you wish to
assign an ACL profile. This field is read-only once you click on a port
number below.
Type the Virtual Path Identifier for a channel on this port.
Type the Virtual Circuit Identifier for a channel on this port.
Use the drop-down list box to select the ACL profile you want to assign
to this PVC.
Click this to save your changes to the IES's volatile memory. The IES
loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Chapter 34 ACL
265).
Section 34.4 on
263