Table of Contents
Advertisement
1-1
Overview
The SuperServer E200-8B is a compact, embedded system comprised of the
SC101S chassis and the X10SBA single processor motherboard. Refer to our
website for information on operating systems that have been certified for use with
the system (www.supermicro.com).
For your system to work properly, please follow the links below to download all
necessary drivers and utilities, and the user's manual for your server.
•
Supermicro product manuals:
•
Product drivers and utilities:
•
Product safety info:
If you have any questions, please contact our support team at:
support@supermicro.com.
This manual may be periodically updated without notice. Please check the
Supermicro website for possible updates to the manual revision level.
1-2
Motherboard Features
The server is built around the X10SBA, a single processor motherboard based on
the Intel Celeron J1900 System-on-Chip (SoC). Below are the main features. Refer
to Figure 1-1 for a block diagram of the system.
Processors
The X10SBA supports a single Intel J1900 64-bit, 22 nm low-power quad-processor
with Intel Silvermont microarchitecture 22nm System-on-Chip.
Memory
The board has two SO-DIMM sockets that can support up to a total of 8GB of
low-voltage, Non-ECC DDR3-1333 SO-DIMM memory. See Chapter 5 for details.
Chapter 1
Introduction
http://www.supermicro.com/support/manuals/
ftp://ftp.supermicro.com
http://super-dev/about/policies/safety_information.cfm
1-1
Chapter 1: Introduction
Advertisement
Table of Contents
