Installing The Hard Drive - Supero SuperServer E200-8B User Manual

SUPERSERVER E200-8B User's Manual
3-4

Installing the Hard Drive

The SC101S can accommodate a single fixed 2.5" hard drive of 9.5 mm thickness.
It is installed to a mounting tray inside the chassis.
Installing the Hard Drive
The motherboard should be installed before installing the hard drive.
1. Make sure there is no power to the system as described in section 3-1 and
remove the chassis cover.
2. Remove the two screws securing the hard drive tray to the support bracket and
set them aside for later use. Lift the tray out.
3. Place the hard drive into the tray and secure it to the tray with the screws
provided with hard drive.
4. Return the hard drive tray assembly into the chassis, aligning the tabs of the
tray with the slots in the chassis. Secure the tray to the chassis support bracket
with the screws previously set aside.
5. Attach the cable SATA connector and to the motherboard connector. This cable
carries both the SATA sginal and the SATA power.
6. Reinstall the chassis cover and power up the system.
Figure 3-3. Installing the Hard Drive
3-4