Onboard Processor - Supero SuperServer E200-8B User Manual

SUPERSERVER E200-8B User's Manual
2-2

Onboard Processor

The E200-8B features an embedded Intel Celeron J1900 processor.
2-3 Installing Memory
Memory Support
The X10SBA motherboard supports up to a total of 8GB of low-voltage, Non-ECC
DDR3-1333 SO-DIMM memory in two low-profile slots. Check the Supermicro
website for a list of memory modules that have been validated.
Installing the Memory DIMMs
Insert one or two SO-DIMMs into the memory slots, starting with JDIMM1 then
JDIMM2. See instructions on the next page.
Exercise extreme care when installing or removing DIMM modules to prevent
damage.
Memory Population Guidelines
Please follow the table below when populating the DIMM slots.
Unbuffered DDR3L Non-ECC SO-DIMM Memory
DIMMs
DIMM Slots
Populated per
per Channel
Channel
2 1
Note: Be sure to use memory modules of the same type, speed and frequency.
DIMM Type POR Speeds
Unbuffered
DDR3 SO- Up to 1333
DIMM
2-2
Memory Population
Sequence
JDIMM1, JDIMM2
(2 DIMMs)