Henny Penny EVOLUTION ELITE EEE-142 Operator's Manual page 75

7-2. ERROR CODES
(Continured
DISPLAY
"E-21"
"E-22"
"NO HEAT"
"CHECK PWR CORD
AND BREAKER"
"E-31"
"E-41", "E-46"
"E-47"
"E-48"
"E-54C"
"E-60"
"E-93-A"
"24 VDC SUPPLY
TRIPPED"
Aug. 2011
CAUSE
Slow heat recovery
Elements not heating
Elements are up
Programming failure
Analog converter chip or 12
volt supply failure
Inpute system error
Temperature inpute error
AIF PC board not
communicating with PC
board
Autolift motor malfunction
or failure
70
Model EEE-141, 142, 143, 144
CORRECTION
Have a certified service technician
check the fryer for correct voltage to the
unit; have heat circuit checked; have
unit checked for loose or burnt wire
Have power cord and heat circuit
checked
Lower elements completely back into
the vat
Press power button to vat off and back
on again, if any of the error codes, have
the controls re-initialized; if error code
persists, have the control board replaced
Press power button to vat off and back
on again, if "E-47" persists, have the
I/O board, or the PC board replaced;
if speaker tones are quiet, probably
I/O board failure; have the I/O board
replaced
Have PC board replaced
Turn switch to OFF, then back to ON;
have control PC board replaced if
"E-54C" persists
Press power button to turn vat off, wait
15 seconds, and turn back on again. If
"E-60" persists, have connector between
the PC boards checked; replace AIF PC
board or control PC board, if necessary
If AutoLift feature is not operating, have
each of the Autolift motors checked