Door Handle Assembly; Baffle Removal - Quadra-Fire 31M-ACC-MBK Manual

3100 Millennium Wood Appliance
D. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in Figure 20.1.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut but do not over tighten, the handle
needs to move smoothly.
7. Install spring handle turning in a counter-clockwise
motion to required 2 inch (51mm) clearance loca-
tion on door handle rod. Figure 20.1.
Door Cross Section
(example)
Latch Cam
Locknut
Spacing
Washers
Figure 20.1
E. Baffle Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffle board has 2 pieces. With the ceramic blanket
still in place, slide one baffle piece over the top of other one
and pull out top piece through the door opening and then
remove bottom baffle piece. Figure 20.2
3. Remove the ceramic blanket.
4. Re-install the baffle pieces one piece at a time. Be sure
the baffle boards are even with the front manifold tube and
is resting on all tubes. Figure 20.4.
5. To re-install the ceramic blanket, it is easier to fold it in
half first. Place on top of baffle board, open up and flatten
and smooth out the blanket. Re-check the baffle board for
correct positioning. Figure 20.3.
Figure 20.2 - Baffle
20
2 inch (51mm) clearance
required from bend in door
handle rod to end of spring
handle.
Spring
Handle
Door Handle
Square Key
7033-329A
Figure 20.3 - Ceramic Blanket
Baffle Board even with front
tube & resting on all tubes
Ceramic Blanket on Top
Tube Channels
Figure 20.4
Burn Rate
Air Control
Automatic
Combustion
Control
2 pc Baffle Board
November 29, 2016