Siemens Milltronics BW500 Operating Instructions Manual page 52

Start Up
6.2 Program Mode
Or press the following for the direct access of parameters:
P940-2 Load Cell mV Signal Test
mV reading for B
For example: access P940-2, load cell B mV signal
To change a parameter value
P011 Design Rate:
Enter Rate
From the view mode
Press the following key:
P011 Design Rate:
Enter Rate
If edit mode is not enabled after pressing ENTER, security is locked. Refer toSecurityLock (P000)
under Parameters for instructions on disabling.
Press the following key to enter the new value
P014 Design Speed
Enter Speed
For P001 to P017, ENTER effects the change and scrolls to the next required parameter.
50
V
6.78
V
100.00 kg/h
E
100.00 kg/h
V
0.08 m/s
BW500 and BW500/L
Operating Instructions, 12/2016, A5E33482052-AD