EverFocus EMV800 HD User Manual page 96

Trans+Timeout: Alarm output continues until event ends, then continues for the set
time duration.
Timeout Duration: The amount of time the buzzer sounds when GPS event occurs.
【GPS Fencing】: You can set up the geo-fencing event for alarm notification.
GPS Alarm: Select On / Off to enable / disable GPS Fencing alarm.
GPS Border Type: Select Circle or Rectangle for the GPS border type.
Coordinate Express: Select DMS to set up the latitude and longitude of the border in Degrees
/ Minutes / Seconds; or select Decimal Degrees to set up the border in decimal degrees.
If you select Circle in the GPS Border Type field, the following settings will appear:
Center Latitude: Select S (South) or N (North) and then set the latitude.
Center Longitude: Select E (East) or W (West) and then set the latitude.
Radius: Select radius value from kilometer (Km) or mile (Mi).
If you select Rectangle in the GPS Border Type field, the following settings will appear:
Upper Left Latitude.: Select S (South) or N (North) and then set the latitude.
Upper Left Longitude: Select E (East) or W (West) and then set the latitude.
Lower Right Latitude: Select S (South) or N (North) and then set the latitude.
Lower Right Longitude: Select E (East) or W (West) and then set the latitude.
【GPS Speed】: You can display the vehicle speed on the live view / recordings or to set up
the higher speed limit event for alarm notification.
GPS Speed: Select whether to display the vehicle speed or not.
Speed Higher Limit: Set the vehicle speed to determine at which level the alarm will be
triggered. Once the vehicle reaches the setup speed, the alarm will be triggered.
Speed Unit: Select KPH (kilometer per hour) or MPH (mile per hour) to display the vehicle
speed on live view or recordings.
Save: Click to save the settings.
EMV800 HD / EMV1200 HD Mobile DVR
86