Front Panel - EverFocus EMV800 HD User Manual

1.4 Front Panel

No. Name
1 USB2.0 Port
2 HDD Drive Tray
3 SD Card Slot
4 Function Key
5 IR Receiver
6 System LEDs
1 2 3
EMV800 HD / EMV1200 HD
Description
Three USB2.0 ports for connecting to the USB storage device or
mouse.
Install a 2.5" HDD for recording.
Insert a SD / SDHC card (up to 32GB) for alarm event backup
recording (see 2.3 SD Card Installation). To see the SD card info, see
6.4.2 SD Card. To enable the SD card function, see 6.3.1 Alarm. You
can also see Appendix G for tested card brands.
This Function key is currently reserved.
Receives data from the infrared remote control.
• Alarm: Turns on when the connected alarm I/O is triggered;
turns off when the alarm I/O stops being triggered.
• GPS: Turns on continuously when the mobile DVR is receiving
GPS data.
• System Fail: Turns off when system is acting normally. Turns on
when these events occur: System Clock Error / Fan Fail / Disk
Temperature Over / Disk Fail / Disk Off / Network Loss.
• Heater: Blinks when heater on; off blinking when heater off.
• HD R/W: Blinks when the HDD is reading or writing.
• Power: Turns on continuously when the power is supplied. Blinks
when Battery power error occurs (lower than 9V or higher than
36V) or 12VDC power supply error.
EMV800 HD / EMV1200 HD Mobile DVR
4 5 6 7 8
5
9 1 10