Sony HVR-M10C Service Manual page 320

6. ADJUSTMENTS
1. Before starting adjustment
< Changed contents (Page 6-2) >
1-1. Adjusting items when replacing main parts and boards.
• Adjusting items when replacing main parts
When replacing main parts, adjust the items indicated by z in the following table.
Note: When replacing the drum assy. or the mechanism deck, reset the data of page: 7, address: A7 to A9 to "00". (Refer to "Record of Use check" of
"6-3. SERVICE MODE")
Adjustment Adjustment
Section
Mechanism Tape path adj.
Initialization of 8,9, Initialization of A, B, D, 1A,1B page data
A,B,C,D,13,18,1A, Initialization of 8, C, 13, 18, 1C page data
1B,1C,1D page data Initialization of 9, 1D page data
System control Serial No. input
CAP FG duty adj.
Servo, RF Switching position adj.
Error rate check
Origin oscillation check
S VIDEO OUT Y level adj.
Video
S VIDEO OUT chroma level adj.
COMPONENT OUTPUT level adj.
LCD automatic adj.
Contrast adj.(HD)
V COM adj.
LCD
Sample hold phase adj.
Transmissive mode white balance adj.
Reflective mode white balance adj.
*1: When the SP (LSI) control microprocessor is replaced, check that the fixed data are corresponding to the version of the microprocessor.
(Refer to "2-2-3. Initialization of 9, 1D page data".)
*2: When the mechanism control microprocessor is replaced, check that the fixed data of the 8 and 13 page are corresponding to the
version of the microprocessor.
(Refer to "2-2-2. Initialization of 8, C, 13, 18, 1C page data".)
HVR-M10C/M10E/M10J/M10N/M10P/M10U
Replaced parts
Block replacement Parts replacement
z z z
z z
z z z
z z z z
z
z z
z z
z z
z z z
z z z
Table. 6-1-1.
— 6 —
Board
replacement replacement
*2
*1
z
z
z z
z z z z z
z z z z z
z
z z
z
z
z
z
z
: Added portion
EEPROM
z z
z z
z z
z z
z z z
z z z
z z z
z
z z
z z z
z z z
z z
z z
z z
z z z