Sony HVR-M10C Service Manual page 189

Apply grease (1)
Tension spring
(Tension regulator)
During installation, apply grease in the TG2 arm pivot shaft hole.
Amount of grease: a ball of grease of 1.0 mm diameter
(Note)
Worm shaft
Deceleration gear
HVR-M10C/M10E/M10J/M10N/M10P/M10U
Application of grease, soldering method and precautions, and phase
matching adjustment are compiled and below.
TG2 arm block assy
Gooseneck gear shaft
Amount of grease: a ball of
grease of 1.0 mm diameter
(Note)
• Do not apply grease to the
wrong position.
• Do not forget to apply grease.
• Do not make mistake about amount of grease.
• When applying grease, do not splash or touch
grease to any other parts and components.
Apply grease
Amount of grease to be applied
: 2.0 mm dia (at 2 locations)
HELP
Note:
Apply grease on the supporting surface of the TG7
pivot shaft.
TG7 pivot
shaft
Apply grease
Re-application of grease to the point which
is greased already before is not necessary.
TG7 arm block assy
Grease application point:
Amount of grease:
a ball of grease of 0.5 mm
diameter
(Note)
Supporting surface
Gooseneck gear shaft
Gooseneck
gear assy
HELP