Sony HVR-M10C Service Manual page 10

2. POWER SUPPLY DURING REPAIRS
In this unit, about 10 seconds after power is supplied to the battery terminal using the regulated power supply (8.4V),
the power is shut off so that the unit cannot operate.
This following two methods are available to prevent this.Take note of which to use during repairs.
Method 1.
Use the AC power adaptor.
Method 2.
Connect the servicing remote commander RM-95 (J-6082-053-B) to the LANC jack,and set the commander switch to the "ADJ" side.
3. TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)
1 Remove the power supply (Battery and AC power adaptor).
2 Remove the bottom cabinet.
3 Disconnect the CN202 (27P, 0.3mm) of MR-048 board.
4 Remove the top cabinet.
5 Supply +4.5V from the DC power supply to the loading motor and unload with pressing the cassette compartment.
HVR-M10C/M10E/M10J/M10N/M10P/M10U
DC power supply
(+ 4.5V)
MR-048 board
1-2
ENGLISH JAPANESE
ENGLISH JAPANESE
CN202