Replacing The Static Cutter Blade - ELNA eXpressive 970 Service Manual

Replacing the Static Cutter Blade

Setscrews
Static cutter blade
1. Remove the setscrews and needle plate.
2. Press Divide key to move the dynamic cutter blade
3. Remove the two setscrews and replace the static
4. Attach the static cutter blade and tighten the set
NOTE:
If the dynamic cutter blade interferes with the left corner
of the static cutter blade when moving the dynamic cutter
Setscrews
blade, shift the static cutter blade to the right.
5. Adjust the cutter blades position (see following pages)
6. Attach the needle plate.
45
forward.
cutter blade.
screws while pressing the static cutter blade in the
direction of the arrow.
and test auto thread cutting.