Adjusting The Take Up Lever Timing - ELNA eXpressive 970 Service Manual

Positioning pin
Setscrew
Cam clamp
Cam clamp
Adjusting the Take-up Lever Timing
Pin groove
Take-up lever cam
Take-up lever cam
To remove:
1. Remove spool stand, head cover (right), right cover and
left cover.
2. Turn the handwheel to set the index disk at 6º.
3. Insert the positioning pin from the left side of the arm.
The positioning pin goes into the pin groove of take-up
lever cam if the timing is correctly adjusted.
4. If the timing is incorrect, loosen the setscrew on the cam
clamp and turn the take-up lever cam so the positioning
pin can go into the pin grove on the cam.
Turn the handwheel to set the index disk at 6º. Tighten
the setscrew on the cam clump while pressing the
take-up lever cam to the side of the dynamic head.
There should be no gap between the take-up lever cam
and cam clamp.
5. Pull the positioning pin out from the arm.
Turn the handwheel to set the index disk at 270º.
Attach the removed parts.
16