Adjusting The Needle Drop Position (Back Or Forth) - ELNA eXpressive 970 Service Manual

Adjusting the Needle Drop Position (Back or Forth)

Needle drop position adjusting plate
Needle hole
1. Set the moving head to needle bar No. 3 (see pages 33
and 46 of the instruction book).
Push the needle bar No. 3 down to engage the needle
bar clutch.
Setscrews
2. Turn the handwheel until the needle goes down into the
needle hole.
Loosen the two setscrews. Adjust the needle drop
position adjusting plate. Center the needle drop position
in the needle hole.
3. Adjust the hook timing (see page 41).
Needle
31