Adjusting The Carriage Home Position - ELNA eXpressive 970 Service Manual

Adjusting the Carriage Home Position

Y-carriage sensor plate
Y-carriage sensor
Front Back
X-carriage sensor
Left Right
Front
X
Y
Jog buttons
Setscrews (A)
X-carriage sensor plate
Setscrews (B)
1. Remove the spool stand, right cover, left cover, base
cover and X-carriage cover (see pages 4 – 7).
2. Attach the Hoop M1 (MB Hoop 240 X 200) to the hoop
supporter.
3. Open the factory adjusting menu window and press
the X/Y Motor key to open the X/Y Motor adjusting
window.
4. Press the jog buttons to move the carriage to where
the center of the hole in the needle plate is positioned
7 mm by 5 mm from the bottom left corner of the inner
sides of the hoop.
5. Loosen the two setscrews (A) slightly.
Move the Y-carriage sensor plate slowly to the front
until the indication under Y changes from "H" to "L".
Tighten the two setscrews (A).
6. Loosen the two setscrews (B) slightly.
Move the X-carriage sensor plate slowly to the left
until the indication under X changes from "H" to "L".
Tighten the two setscrews (B).
NOTE:
The sensors should not interfere with the carriage.
7. Attach the parts removed in step 1.
63