Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual page 504

Converting a tower model to a rack model
Figure 374: Securing the accessible drive cage (B)
Ê Carefully turn the server upside down.
I
At least two people are needed to turn over a fully equipped server.
Remove HDDs and PSUs in order to facilitate the task.
Ê Secure the accessible drive cage with the two screws (see circles) to the
bottom side of the server.
I
Note the correct screw positions: The screw hole on the right that has
been used in the tower configuration remains empty.
Ê Install the front panel module as described in section
panel module" on page
Ê If applicable, install all accessible drives as described in section
an accessible drive" on page
Ê If applicable, install an HDD extension box as described in section
extension boxes" on page
Preparing the intrusion switch
Ê Remove the intrusion switch module as described in section
intrusion switch cable" on page
Ê Attach a rubber bumper (C26192-Y26-C43) to the front intrusion switch and
reinstall the intrusion switch module as described in section
intrusion switch cable" on page
504
440.
398.
237.
534.
537.
Upgrade and Maintenance Manual
"Installing the front
"Installing
"HDD
"Removing the
"Installing the
TX2560 M2 / RX2560 M2