Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual page 491

"Looking up changed MAC / WWN addresses" on page 137
Ê
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 134
"Enabling SVOM boot watchdog functionality" on page 130
Ê
"Resuming BitLocker functionality" on page 136
Ê
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer. For further information, please refer to section
network settings recovery" on page 484
configuration" on page
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing the system board" on page
TX2560 M2 / RX2560 M2
340.
Upgrade and Maintenance Manual
System board and components
and section
140.
"Note on
"Software
491