Installing Controller Software Using An External Compactflash Card (Optional Initial Install) - Mitel SX-200 ICP Technician's Handbook

SX-200 ICP CX/CXi Technician's Handbook
Installing Controller Software Using an
External CompactFlash Card (Optional Initial
Install)
The SX-200 ICP is shipped from the factory with the system software and
a default database installed. Perform this procedure only if you,
• are upgrading the system software on site
• require a language other than the default English for voice mail prompts
or a second language for bilingual voice mail operation
• are replacing the internal CompactFlash card or installing a system
hard drive on systems currently equipped with internal CompactFlash.
For replacement instructions, see page 182.
• are re-initializing the controller
Note: The "Initial" power-up and the reset in this procedure will each take 5
to 10 minutes.
To install software using an external CompactFlash card:
Important: Use only Mitel-supplied CompactFlash cards. DO NOT
partition the card and DO NOT copy files to it before proceeding
with the software installation.
1. Launch the SX-200 ICP Installation program on the supplied
CD-ROM.
2. Select "Initial [CompactFlash Card] Installation", and then click Next.
3. Select the voice mail language(s) that you want to install, and then
click Next.The default is English and is not selectable.
Note: The additional languages enable the embedded voice mail system to
operate with bilingual prompts. Bilingual prompts is a purchasable MOSS
option.
4. Specify the drive letter of the CompactFlash Reader/Writer.
5. Select Format to format the CompactFlash card.
Note: When formatting the CompactFlash card, specify FAT as the file
system.
6. Select a database, then click Next.
48