Checking The Status Leds - Mitel SX-200 ICP Technician's Handbook

Checking the Status LEDs

Figure 19: Controller Status LEDs (CXi controller)
Note: The CXi controller is shown in Figure 12. Status LEDs and their
meaning are the same for the CX controller.
LED Status
GREEN - on solid
RED - two successive
flashes
RED - on 2 seconds
RED - on solid
RED - blinking
OFF
Basic Troubleshooting and Repair
Table 34: Power LED
Unit is plugged in and operating normally.
The unit is starting up properly (seen only during the
boot process).
The unit is starting up properly (seen only during the
boot process).
The unit has detected an error and is being held in
reset mode until the problem is corrected.
The unit has detected an error during the power-on
process and will attempt to reset itself.
Unit is not plugged in OR
Unit is faulty.
Meaning
217