Sorter (Service Mode For Delivery Options); Adjust (Adjustment Mode); Option (Specification Setting Mode) - Canon imageRUNNER ADVANCE C255 Series Service Manual

SORTER (Service mode for delivery options)

ADJUST (Adjustment mode)

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
ST-ALG1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit

OPTION (Specification setting mode)

SORTER (Service mode for delivery options) > OPTION (Specification setting mode)
MD-SPRTN 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Adjustment of alignment position
To adjust the alignment position.
As the value is incremented by 1, the travel length of the Alignment Plate is increased by 0.25 mm.
- When misalignment occurs
- When adjusting the alignment position according to paper width and degree of paper curl
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Be sure to make an adjustment according to the paper width the user uses and degree of curl.
-20 to 20
mm
0
0.25
Set restriction at Finisher error
To set whether to stop the machine when an error occurs at Finisher.
When preferring to run the machine at Finisher error
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When "1" is set, staple operation or alignment operation is not executed. Set "0" normally.
0 to 1
0: Normal, 1: Function restriction
0
858
8. Service Mode