Canon imageRUNNER ADVANCE C255 Series Service Manual page 625

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > CCD
OFST-CL0 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST-CL1 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST-CL2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
OFST-CL3 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
Adj CIS-ch0 offset:front,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 0 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch1 offset:front,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 1 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch2 offset:front,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 2 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
Adj CIS-ch3 offset:front,clr mode,300dpi
To adjust the offset value (black level) of the Scanner Unit (Front) on channel 3 in color mode with
300 dpi.
The value is updated by executing CL-AGC.
- When replacing the Main Controller PCB/clearing the Reader-related RAM data/replacing the
SATA Flash PCB
- When replacing the Scanner Unit (Front)
Enter the setting value, and then press OK key.
0 to 255
216
COPIER> FUNCTION> CCD> CL-AGC
614
8. Service Mode