Canon imageRUNNER ADVANCE C255 Series Service Manual page 695

COPIER (Service mode for copier) > ADJUST (Adjustment mode) > FEED-ADJ
REG-ENV 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
REG-MFPC 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
ADJ-ENV 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Appropriate Target Value
Default Value
Related Service Mode
Amount of Change per
Unit
Adj ppr lead edge margin: envelope, cst
To adjust the leading edge margin of envelope that is fed from a cassette by changing the timing
to turn ON the Registration Motor.
As the value is changed by 1, the leading edge margin is changed by 0.1 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge side.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge side.)
When replacing the DC Controller PCB/clearing RAM data, either restore the backup data or enter
the value of service label.
- When adjusting the leading edge margin
- When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
The value differs according to the product configuration.
0.1
Adj ppr lead edge margin: postcard, MP
To adjust the leading edge margin of postcard that is fed from the Multi-purpose Tray by changing
the timing to turn ON the Registration Motor.
As the value is changed by 1, the leading edge margin is changed by 0.1 mm.
+: Leading edge margin becomes larger. (An image moves to the trailing edge side.)
-: Leading edge margin becomes smaller. (An image moves to the leading edge side.)
When replacing the DC Controller PCB/clearing RAM data, either restore the backup data or enter
the value of service label.
- When adjusting the leading edge margin
- When replacing the DC Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
-50 to 50
mm
The value differs according to the product configuration.
0.1
Cst1 write start pstn in horz scan:envlp
To adjust the image write start position in the horizontal scanning direction when feeding envelope
from the Cassette 1.
To specify the position of envelope relative to the position specified by ADJ-C1.
As the value is changed by 1, the left margin is changed by 0.1 mm.
+: Left margin becomes larger. (An image moves to the right.)
-: Left margin becomes smaller. (An image moves to the left.)
Upon user's request
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
In principle, the image write start position of envelope needs to be set with printer driver by the
user. If the user points out that it is bothersome to make a setting whenever making an output, set
this item.
-23 to 15
mm
-8
-8
COPIER> ADJUST> FEED-ADJ> ADJ-C1
0.1
684
8. Service Mode