Canon imageRUNNER ADVANCE C255 Series Service Manual page 817

COPIER (Service mode for copier) > OPTION (Specification setting mode) > ACC
MEAP-SRL 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
OPCST-BA 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
CV-CSZ 1
■ INT-FACE
COPIER (Service mode for copier) > OPTION (Specification setting mode) > INT-FACE
NWCT-TM 2
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
■ LCNS-TR
COPIER (Service mode for copier) > OPTION (Specification setting mode) > LCNS-TR
ST-SEND 2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Set to allow serial comctn from MEAP app
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to allow serial communication of MEAP application.
When 1 is set, serial communication of the machine is stopped and only the serial communication
with MEAP application is available.
When performing serial communication from MEAP application
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Prohibited, 1: Allowed
0
Set Cst Pedestal not connect error stop
To set whether to stop the error that occurs when the Cassette Pedestal has not yet been
connected.
When 1 is set, the error does not occur even though operation check is performed only for the host
machine.
When performing operation check for the host machine with no option cassette connected at the
time of installation
Enter the setting value, and then press OK key.
Be sure to return the value to 0 before the machine is used by the user.
0 to 1
0: Normal, 1: Error not displayed
0
[For customization]
Timeout setting of network connection
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the time to keep network connection between this machine and the PC application (keep-
alive setting).
As the value is incremented by 1, the time is increased by 1 minute.
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 5
5
Expected PC application: Network print application, E-mail function, cascade copy, MEAP network
application, etc.
Installation state dspl of SEND function
To display installation state of SEND function when transfer is disabled.
When checking whether SEND function is installed
1) Select ST-SEND.
2) Enter 0, and then press OK key.
When installation has been completed, the transfer license key is displayed under TR-SEND.
When operation finished normally: OK!
According to the setting at shipment
806
8. Service Mode