Table of Contents
Advertisement
③ Insert the power supply plug of the power supply code in the outlet of AC power supply.
[Installation of battery]
① Draw the battery to the lock lever side and put it on the battery pocket. The battery is
firmly installed on the battery pocket.
② Press down the battery and then slide it to the opposite direction of the lock lever.
③ The lock lever goes up, and the battery is fixed.
④ Under such a condition, if "Connection of the code" is done, the charge with the battery
is begun.
Lock lever
[Detaching the battery]
① Press the lock lever and slide the battery to the lock lever direction.
② Detach the battery packing from the battery pocket.
[Display panel]
Installation lamp
Charge lamp
① Power supply lamp (red) :
② Charge lamp (green) :
③ Discharge lamp (yellow) :
④ Installation lamp (red) :
14
Turns on when the power supply is turned on.
Turns on while charging and turns off when the charge is
completed.
Turns on when you push the discharge button.
Turns off when the discharge is completed.
Blinks or turns on when the battery packing is attached
normally.
Blinks when charge or discharge and turns on when charge is
completed.
(The charge lamp in the lower does not blink and does not
turns on)
Battery
Battery pocket
Charger
Power supply lamp
Discharge lamp
Discharge button
Hide quick links:
Advertisement
Table of Contents
