Table of Contents
Advertisement
HOW TO USE THE ELLIPTICAL
HOW TO EXERCISE ON THE ELLIPTICAL
To mount the elliptical exerciser, hold the upper body arms
and step onto the pedal that is in the lowest position. Then,
step onto the other pedal. Push the pedals until they begin
to move with a continuous motion.
Note: The pedal discs can turn in either direction. It is rec-
ommended that you move the pedal discs in the direction
shown by the arrow;however, for variety, you may turn the
pedal discs in the opposite direction.
The upper body arms are designed to add upper-body
exercise to your workouts. As you exercise, push and pull
the upper body arms to work your arms, shoulders, and
back. To focus on lower-body exercise, hold the upper
body arms but do not push or pull them as you exercise.
To dismount the elliptical exerciser, wait until the pedals
come to a complete stop.
Note: The elliptical exerciser does not have a free wheel;
the pedals will continue to move until the flywheel stops.
When the pedals are stationary, step off the highest pedal
first. Then, step off the lower pedal.
WHEN YOU ARE FINISHED EXERCISING
If the pedals do not move for several minutes and the but-
tons are not pressed, the console will turn
display will be reset.
HOW TO USE THE TABLET HOLDER
IMPORTANT: The tab-
let holder is designed
for use with most full-
size tablets. Do not
place any other elec-
tronic device or object
in the tablet holder.
To insert a tablet into the
tablet holder, set the bottom edge of the tablet in the tray.
Then, pull the clip over the top edge of the tablet. Make
sure that the tablet is firmly secured in the tablet holder.
Rotate the tablet holder to the desired angle. Reverse
these actions to remove the tablet from the tablet holder.
IMPORTANT: If the elliptical has been exposed to cold
temperatures, allow it to warm to room temperature
before you plug in the power adapter. If you do not do
this, you may damage the console displays or other
electronic components.
Plug the power adapter
into the receptacle on
the frame of the elliptical.
Insert the appropriate plug
adapter into the power
adapter
if
necessary.
Then, plug the power
adapter into an appropri-
ate outlet that is properly
installed in accordance
with all local codes and
ordinances.
`
NOTE: Power hole is designed on the back of the
console
12
off and the
Advertisement
Table of Contents
