Replacing The Battery; Removing The Battery; Installing A Battery - Kurzweil K2600 Series Service Manual

Replacing the Battery

The K2600 uses a flat three volt Lithium coincell battery. When the battery voltage runs low, the
K2600 boots up with a low battery message. The LEDs flashing three times on power up is also
an indicator that the battery is low.
Note: The battery voltage can be checked at anytime using the Scanner Diagnostics. See
page 5-6 for more information.

Removing the Battery

The K2600 battery (CR2032) is mounted into a horizontal holder and is accessible when the
access panel is removed.
1. Remove the six screws that secure the access panel and set it safely aside.
2. If a P/RAM SIMM is installed at J803, remove it to provide accessibility.
3. Insert a flat plastic tool (plastic knife, pen cap, etc.) into one of the openings between the
4. Ease the battery out of the holder. If necessary, insert the plastic tool at the back of the

Installing a Battery

1. Position the battery over the holder so that the positive terminal is pointing to the rear
2. Slide the battery into the holder and apply slight pressure until it snaps into place.
3. Replace the P/RAM SIMM at J803.
4. Install the six screws to secure the access panel.
battery and the front of the holder (toward the front panel) to lift the battery.
Insert the tool here
to lift the battery.
Figure 5-2 Battery and holder
Caution: Be sure no damage occurs to the electrolytic capacitor (C37) located next to the
battery.
holder (close to rear panel) to remove the battery.
panel.
CR2032
Insert the tool between
the holder and the battery
to ease the battery out
of the holder.
Troubleshooting
Replacing the Battery
5-5