Rear Panel Features; All Models; Keyboard Models Only; Rack Models Only - Kurzweil K2600 Series Service Manual

Rear Panel Features

All Models

• Mix Outputs, use these two 1/4" jacks (Left is mono) to connect either T/S or T/R/S cables.
• Analog Outputs Bal/Unbal, configure these 1/4" jacks (four pairs, A–D) as stereo pairs of
individual mono outputs.
• SCSI ports, use these two ports to connect a hard drive or other SCSI devices.
• SCSI Termination switch, a slide switch to select either Auto or Disable for SCSI
termination.
• MIDI ports, In, Thru/Out, and Out, to use with other MIDI devices to receive, pass, and
send MIDI data.
• MIDI Select switch, a slide switch to select the operation of the Thru/Out port.
• Kurzweil I/O, use these serial ports to send or receive the Kurzweil KDS format.
• Digital I/O, use these XLR jacks to send or receive digital information.
• Optical Out, use this jack to send or receive digital information from external devices with
an optical in jack.

Keyboard Models only

• Power Entry Module, includes the power switch, AC connector, fuse holder, and voltage
select switch.
• LCD Contrast, turn this potentiometer to adjust the LCD for the best visibility.
• CC Pedals/Breath, use these two 1/4" jacks to connect external control pedals (10kΩ linear
taper potentiometer, ring/tip/sleeve). Use the 3.5mm jack to connect a breath controller.
• Switch Pedals, use these four 1/4" jacks to connect footswitches.
• Inputs, this section is covered by a plate if the sampling option is not installed.
• Headphones: use this 1/4" jack to connect headphones.

Rack Models only

• Power Entry Module, includes the AC connector, fuse holder, and voltage select switch.
• For units with the sampling option, use either the two Lo Z XLR or the Hi Z 1/4"
(tip/ring/sleeve) jacks for sampling from an analog source.
• Optical In, If sampling from a digital source with an optical out jack, use this input.
Introduction
Rear Panel Features
1-3