K2600X Keyboard Assembly; Removing The K2600X Keyboard Assembly - Kurzweil K2600 Series Service Manual

K2600/K2600X Disassembly/Assembly

K2600X Keyboard Assembly

K2600X Keyboard Assembly

Removing the K2600X Keyboard Assembly

The following procedure assumes that the K2600X is open and that you have followed the
instructions to remove the top enclosure.
1. The keyboard is secured to the bottom enclosure using nine screws. Refer to Figure 4-13
2. Tilt the K2600X up and remove the four keyboard rear screws, then lay the K2600X flat on
3. Move the K2600X forward so that the front hangs over the edge of your work surface to
4. Remove the four Mod Wheel screws and washers. At this point the keyboard is loose in
Keyboard
Mod Wheel screws
Rear panel
5. Slide the K2600X back onto your work surface.
6. Lift the Mod Wheel Assembly and disconnect the Aftertouch flex cables. These cables
7. Place the Mod Wheel Assembly in its position on the bottom enclosure.
8. Remove the cable locking clip and disconnect the flat ribbon cable from the Keyboard
9. Remove the Keyboard Assembly.
4-28
for the position of the screws. Arrows identify the locations of the nine screws.
your work surface.
access the remaining screws, and remove the five keyboard front screws.
the bottom enclosure, but it has cables connected to the Mod Wheel Assembly and the
Keyboard Scanner Board.
Figure 4-13 K2600X 88-note keyboard bottom
have nylon reinforced tape securing them to the bottom enclosure. Peel back the tape from
one side to free the cables.
Scanner Board. This cable is also secured to the bottom enclosure with nylon reinforced
tape. Peel back the tape from one side to free the cable.
Note: If you are merely replacing one or more keys, it is not necessary to entirely remove
the Keyboard Assembly from the K2600X. Follow the procedure on page 4-29.
Keyboard front screws
Keyboard rear screws
Access panel