Opening The K2600/K2600X; K2600 Bottom - Kurzweil K2600 Series Service Manual

K2600/K2600X Disassembly/Assembly

Opening the K2600/K2600X

Opening the K2600/K2600X

K2600 Bottom

1. Refer to Figure 4-1. Remove the enclosure support wall screws and the endblock locking
2. Tilt the K2600 up and remove the seven enclosure support wall screws. These attach the
3. Remove the four endblock locking brackets screws (two on each side of the bottom
4. Slide the endblock locking brackets out of the K2600 and set them aside.
Keyboard
Rear panel
5. Place the K2600 flat on your work surface.
4-2
bracket screws (not the endblock screws). Dotted lines indicate the locations of the
enclosure support wall screws. Arrows show the locations of the endblock locking bracket
screws.
Note: Do not remove the five endblock screws at this point.
support wall to the bottom enclosure.
enclosure).
Note: The left and right endblock locking brackets are identical. Therefore, you don't
need to keep them separate.
Endblock locking bracket screws
Figure 4-1 K2600 bottom enclosure
Enclosure support wall screws
Access panel