Front Panel Assembly; Removing The Front Panel Cover; Replacing The Front Panel Cover; Removing The Front Panel Mounting Bracket - Kurzweil K2600 Series Service Manual

K2600R Disassembly/Assembly

Front Panel Assembly

Front Panel Assembly

Removing the Front Panel Cover

1. Place the K2600R on its side and remove the four screws along the bottom edge of the
2. Place the K2600R flat in its normal position.
3. From the Optical Inputs section of the front panel, remove the cap from the Optical jack.
4. Remove the nut and washer from the Optical Input 1/4" jack on the front panel cover and
5. From the Data Entry section of the front panel, remove the nut and washer from the
6. Remove the two screws from the top right and left corners of the front panel cover.
7. Remove the front cover. Place it safely aside to avoid damage.

Replacing the Front Panel Cover

1. Place the front cover in position. Be sure that the front panel switches, knobs, jacks, and
2. Install the four screws (use a #1 screwdriver) that secure the front cover to the Optical
3. Install the nut and washer that secure the Headphone jack, and install the nut and washer
4. Install the two screws that secure the top right and left corners of the front panel cover.
5. Place the K2600R on its side and install the four screws along the bottom edge of the front

Removing the Front Panel Mounting Bracket

1. Remove the front panel cover, as described on page 3-12.
2. Remove the two brass screws that secure the power switch to the Front Panel/Scanner
3-12
front panel cover.
the four screws (use a #1 screwdriver) from the Optical Input XLR jacks.
Headphone jack.
potentiometers are correctly positioned and visible through the openings provided for
them on the front panel cover.
Input XLR jacks, and install the Optical jack cap.
that secure the Optical Input 1/4" jack.
panel cover.
Board, and slide the power switch assembly into the K2600R to clear it from the Front
Panel/Scanner Board and the front panel mounting bracket.