Opening The Pc3X; Pc3X Bottom - Kurzweil PC3x Service Manual

Disassembly/Assembly

Opening the PC3x

Opening the PC3x

PC3x Bottom

Refer to Figure 3-1. Arrows indicate the locations of the enclosure support wall, endcap and rear
panel screws.
Keyboard
*
Rear panel
Caution: Do not remove the endcap or rear panel screws at this point of the procedure.
1. Tilt the PC3x up and remove the four enclosure support wall screws.
2. Place the unit flat on your work surface.
3. Move the unit so that the rear panel portion of the unit hangs over the edge of your work
Note: Two of these screws also secure the rear panel portion of the access panel. It is not
necessary to remove the five remaining access panel screws.
4. Slide the unit back onto the work surface.
3-2
Enclosure support wall screws
Figure 3-1 PC3x bottom enclosure
surface. This gives you access to the eight screws that secure the rear panel portion of the
top enclosure to the bottom enclosure. Remove the eight screws.
Rear panel screws
Access panel
*Endcap locking bracket screws
*