Hard Drive - HP Envy x360 m6 Series Maintenance And Service Manual

Hard drive

NOTE: The hard drive spare part kit does not include the hard drive bracket, cable, or screws. The hard drive
bracket and screws are available using spare part number 856789-001. The hard drive cable is available using
spare part number 856788-001.
Description
2-TB, 5400-rpm, SATA, 9.5-mm hard drive
1-TB, 7200-rpm, SATA, 9.5-mm hard drive
1-TB, 5400-rpm, SATA, 8-GB hybrid, 9.5-mm hard drive
Before removing the hard drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the hard drive:
1. Release the zero insertion force (ZIF) connector (1) to which the hard drive cable is connected, and then
disconnect the hard drive cable from the system board.
2. Detach the hard drive cable (2) from the keyboard/top cover. (The hard drive cable is attached to
the keyboard/top cover with double-sided adhesive.)
3. Remove the four Phillips PM2.0×4.6 screws (3) that secure the hard drive to the keyboard/top cover.
30 Chapter 5 Removal and replacement procedures
Bottom cover on page 27).
Spare part number
801808-005
766644-005
731999-005
Battery on page 29).