Fan/Heat Sink Assembly - HP Envy x360 m6 Series Maintenance And Service Manual

Fan/heat sink assembly

Description
Fan/heat sink assembly (includes replacement thermal material)
Before removing the fan/heat sink assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the fan/heat sink assembly:
1. Disconnect the fan cable (1) from the system board.
2. Release the display panel cable (2) from the retention clips and channel built into the fan.
3. Loosen the four Phillips PM2.0×6.2 captive screws (3) that secure the fan/heat sink assembly to
the system board.
4. Remove the three Phillips PM2.0×4.6 screws (4) that secure the fan to the keyboard/top cover.
5. Remove the fan/heat sink assembly (5).
NOTE:
removing the fan/heat sink assembly. The fan/heat sink assembly is attached to the connector board
cable with double-sided adhesive.
Bottom cover on page
It is necessary to detach the fan/heat sink assembly from the connector board cable (6) when
27).
Battery on page 29).
Component replacement procedures
Spare part number
856277-001
39