Part Removal And Replacement; Threader Plate - ELNA 6001 Service Manual

PDFMAILER.DE
If the hook of the threader plate is damaged, change or adjust the part as follows:
TO REMOVE:
1. Push down the needle threader knob and pull the needle threader plate (A) down to remove it
(See Fig.1).
2. To install the needle threader plate, line the groove up with the pin (B) and push it up to snap
fit.
1. To adjust the threader plate position:
2. If the hook on the threader plate touches the left or right side of the needle guide, loosen
setscrew (C) and adjust the hook position (Fig.2).
3. If the hook on the threader plate touches the top or bottom side of the needle guide, loosen
setscrew (D) and adjust the hook position (Fig.3).

THREADER PLATE

24