Driving Motor (Dc Motor) - ELNA 6001 Service Manual

PDFMAILER.DE
TO REMOVE
1. Remove the front cover (see page 11).
2. Remove the belt.
3. Pull out the motor connector from the A-board.
4. Remove screws (A) and (B).
5. Take off the driving motor.
TO ATTACH
1. Set the motor in machine and replace screws (A) and (B).
2. Snap the motor connector into the connector post (E) on the A-board.
3. Replace the motor belt.
4. Move the motor mounting bracket (C) up and down while applying approximately 300 grams
pressure in the middle of the belt, it should deflect 7 to 9 mm when set properly.
5. Tighten screws (A) and (B).
6. Replace the belt and front cover.

DRIVING MOTOR (DC MOTOR)

29