Parameter Assignment With Fb 45/55 And Fc 56; Input Parameters For Asm 456 - Siemens ASM 456 Operating Instructions Manual

Parameterization

5.3 Parameter assignment with FB 45/55 and FC 56

5.3 Parameter assignment with FB 45/55 and FC 56
5.3.1

Input parameters for ASM 456

Input parameters for ASM 456 with FB 45
The assignment is made in UDT 10.
Table 5- 2 Input parameters for ASM 456 with FB 45
Address Name
+0.0 ASM_address
+2.0 ASM_channel
+8.0 MDS_control
+9.0 ECC_mode
+9.1 RESET_long
+10.0 MOBY_mode
+11.0 scanning_time
+12.0 option_1
+13.0 distance_limiting
+14.0 multitag
+15.0 field_ON_control
+16.0 field_ON_time
You will find special information on the input parameters for ASM 456 with FB45 in
combination with the RF620R/RF630R readers in the section "Parameterizing >
Parameterizing RF620R/RF630R with FB 45 > Input parameters" in the "Configuration
Manual RF620R/RF630R".
36
Permissible values
256, 260, 264, 268, ...
1, 2
B#16#0, 1
TRUE, FALSE
TRUE, FALSE
B#16#1, 4, 5, 6, 7, 8,
9, A, B
5
MOBY I:
B#16#00 ... FF
MOBY U:
B#16#00 ... C8
B#16#00, 02, 04
MOBY U (normal transmit
power):
B#16#05, 0A, 0F, 14,
19, 1E, 23
MOBY U (reduced trans-
mit power):
B#16#85, 8A, 8F, 94,
99, 9E, A3
MOBY D:
B#16#02 ... 28
B#16#1
MOBY U:
B#16#0, 1, 2, 3
MOBY D, RF300:
B#16#0
MOBY U:
B#16#00 ... FF
MOBY D:
B#16#00, 01
Comment
Each ASM 456 occupies four bytes of I/O in
the I/O area of the controller.
0 = no presence check
1 = presence check
TRUE,
if MOBY_mode = 5 (MOBY U/D; RF200, RF300,
RF600)
Special features of the MOBY I dialog (8):
•
Write/read device must be type SLG4x.
•
The VMDS memory size is 16KB. The INIT
command for the VMDS must be specified
using 4000 hex.
RF300 filehandler
A value not equal to 00 is only practical
if parameters for MOBY_mode have been set
accordingly.
MOBY D, RF200, RF300 reserved (00)
MOBY U/D
RF200, RF300 reserved (00)
MOBY U/D, RF200, RF300
MOBY U/D, RF200, RF300
MOBY U/D
RF200, RF300 reserved (00)
Operating Instructions, 07/2015, J31069-D0162-U001-A6-7618
ASM 456 interface module