Removing The Asm 456 - Siemens ASM 456 Operating Instructions Manual

3.5

Removing the ASM 456

Procedure
The ASM 456 is wired up and operational. Follow the steps below to remove the ASM:
1. Switch off the supply voltage for the ASM 456.
2. Disconnect the wiring from the terminal block.
3. Undo the 4 securing screws of the terminal block.
4. Remove the terminal block from the basic device.
5. Disconnect the wiring on the basic device.
6. Remove the securing screws from the basic device.
ASM 456 interface module
Operating Instructions, 07/2015, J31069-D0162-U001-A6-7618
Installation
3.5 Removing the ASM 456
15