Installing The I/O Module - Siemens ASM 456 Operating Instructions Manual

Installation

3.2 Installing the I/O module

3.2 Installing the I/O module
Simple installation
The ASM 456 is designed for easy mounting.
Properties
● The I/O module should be mounted on a solid surface.
● The I/O module can be prewired (without installed terminal block).
Requirements
The following table shows the screws suitable for installing the I/O modules:
Table 3- 2
Screw type
M5 cylinder head screw according to
ISO 1207 / ISO 1580 (DIN 84 / DIN 85)
Cylindrical head screw with M5 hexagon socket
according to DIN 912
Tools required
Medium-sized cross-head screwdriver or 8 mm socket wrench.
Procedure
Screw-mount the I/O module on a plane surface.
Screw the I/O module onto the panel at both mounting fixtures at the front top and bottom.
Tightening torque: 3 N/m.
12
Screw types
Description
The minimum screw length must be 20 mm.
You also need a set of DIN 125 washers.
Operating Instructions, 07/2015, J31069-D0162-U001-A6-7618
ASM 456 interface module