Change Batteries; Restart - La Crosse Technology 327-1414Wv2 Instructional Manual

Change Batteries

TX141W Sensor:
1. Grab the vented portion of the sensor and turn counter clockwise.
2. Remove old batteries and install fresh "C" batteries.
3. Carefully align and turn vented portion clockwise to tighten.
4. Hold the DOWN ARROW button on the weather station for 5 seconds
to search for the sensor.
TX141TH-BCH Add-on Sensor(s):
1. Slide battery cover down and lift off sensor.
2. Remove old batteries and install fresh "AA" batteries.
3. Hold the DOWN ARROW button on the weather station for 5
seconds to search for the sensor.

Restart

1. Bring in the Wind sensor and any other add-on sensors connected
to the weather station. Set them all within 5 feet from the station.
2. Remove batteries from the sensor (s) and batteries and power cord
from the weather station
3. Press any button 20 times and wait at least 15 minutes.
4. After the 15 minutes, insert batteries into the wind sensor, then
insert the power cord and/or batteries back into the weather
station. The outdoor data should show up on screen within a
minute or two.
5. Once the outdoor data is showing up, wait another 15 minutes for
the sensor and station to establish a strong connection.
6. After the sensor(s) have been connected for at least 15 minutes,
feel free to mount them back outside.
Page | 9
TX141W Sensor
www.lacrossetechnology.com/support/
Add-On Sensor
1 2 3
327-1414Wv2