Position Add-On Sensors; Position Wind Sensor - La Crosse Technology 327-1414Wv2 Instructional Manual

Position Add-on Sensors

• Mount the TX141TH-BCH add-on sensor on a north-facing wall or in
any well shaded area. Under an eave or deck rail is preferred.
• The maximum wireless transmission range to the weather station is
over 300 feet (91 meters) in open air, not including walls or floors.
• Be sure the sensor is mounted vertically
Option 1:
• Install one mounting screw into a wall leaving some extended.
• Place the transmitter onto the screw.
• Gently pull the transmitter down to lock the screw into place.
Option 2:
• Insert the mounting screw through the front of the transmitter and
into the wall.
• Tighten the screw to snug (do not over tighten).

Position Wind Sensor

• For the most accurate wind speed readings, mount the TX141W
sensor as the highest object for 50 feet in all directions.
• Cups should be on the top of the sensor. Mount vertically.
• The maximum wireless transmission range to the wind station is
over 300 feet (91 meters) in open air, not including walls or trees.
1. Insert mounting pole into sensor.
2. Tighten screws
3. Insert bottom of pole into mounting bracket
4. Tighten knob to secure
5. Use screws through the bottom of the
mounting bracket to attach.
6. The sensor can be mounted from
the bottom or side. (the picture is
of the sensor mounted from the side)
Alternatively:
1. Insert your own mounting pole into
the sensor.
2. Tighten screws
3. Mounting bracket would not be used.
Note: Do not attempt to insert a pole into the hollow back of the
mounting bracket.
Page | 11
www.lacrossetechnology.com/support/
327-1414Wv2