Table of Contents
Advertisement
HOW DO I SILENCE OR TURN OFF AN ALERT?
Silence Alert Beeps: To silence an active alert press any button. The alert will stop
beeping but the icon will flash.
Disarm Alerts:
1. Hold the ALERTS button 3 seconds to enter alert set mode.
2. Press and release ALERTS button until you see the alert you wish to disarm.
3. Press the PLUS or MINUS button to disarm the alert. The alert text goes from ON to
OFF.
4. Press the LIGHT button to exit.
HOW DO I CHANGE BATTERIES IN MY SENSORS WITHOUT LOSING DATA?
We designed this station for convenience, so that a simple change of batteries does not
lose data or require you to power down your station.
•
If you have a low battery icon on your station, you need to replace the batteries in the
sensor indicated.
•
Simply install fresh
To search for a sensor:
•
In normal mode press and release the SENSOR button to view individual sensor ID's
for up to 15 seconds.
•
When you see the sensor's ID number, press and release the + button to search for
that sensor.
In the rare event you need to replace your sensor, you will first need to delete the old
sensor ID from your station.
1. Remove batteries from your old sensor.
2. Press and release the SENSOR button to view your sensor ID number.
3. While viewing your sensor ID, hold the MINUS button for 5 seconds to delete your old
sensor ID. Dashes will show for the ID number.
4. Your station will automatically begin searching for the new sensor.
5. Install batteries in your new sensor and allow up to three minutes for your new sensor
readings and ID to appear on your station.
DASHES TEMP/HUMIDITY: WHY DOES MY THERMO-HYGRO SENSOR SHOW
Dashes indicate the connection is lost between your station and the outdoor sensor.
La Crosse Technology, Ltd.
TROUBLESHOOTING
batteries
into your sensor then search for your sensor.
HOW DO I DELETE SENSOR ID NUMBERS?
DASHES ON THE STATION?
Page 7
Advertisement
Table of Contents
Troubleshooting
