Position Weather Station; Replace Wind Cups; Care And Maintenance - La Crosse Technology 327-1414Wv2 Instructional Manual

Position Weather Station

• Pull out the stand and place on a flat surface.
• Or use the three hanging holes on the back to mount on the wall,
near an outlet for constant backlight.
1. Choose a location 6 feet or more away from electronics such as
cordless phones, gaming systems, televisions, microwaves,
routers, etc.
2. Place within range of the outdoor sensors (300 ft, 91m open air).
3. Obstacles such as walls, windows, stucco, concrete, and large metal
objects can reduce the range.
4. For best WWVB reception, orientate the weather station with the
front or back of the station facing Ft. Collins, Colorado.

Replace Wind Cups

1. Loosen the screw
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will fit on the flat side of the metal
stem on the sensor.
Flat Side Of
Stem Up

Care and Maintenance

• Do not mix old and new batteries
• Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries
• Always purchase the correct size and grade of battery most suitable
for intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to
battery installation.
• Ensure the batteries are installed with correct polarity (+ and -).
• Remove batteries from equipment which is not to be used for an
extended period of time.
• Promptly remove expired batteries.
327-1414Wv2
www.lacrossetechnology.com/support/
Insert and Attach
Flat End up
Page | 12