10
TUNING THE CHASSIS
10.16
Handlebar position
10.17
Adjusting the handlebar position
The holes on the handlebar supports are placed at a distance of
Hole distance A
The handlebar can be mounted in 2 different positions. In this way, the handlebar can
be mounted in the most comfortable position for the rider.
H01188-10
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handlebar support
H01189-11
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar support with screws
the handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar clamp
Finishing work
–
Mount the handlebar cushion.
3.5 mm (0.138 in)
. Take off the handlebar clamp. Take off the handlebar and lay
. Take off handlebar supports
and push through nuts
.
M10
but do not tighten yet.
evenly.
from the center.
.
from below.
40 Nm
Loctite
(29.5 lbf ft)
onto the longer, higher side of
M8
20 Nm (14.8 lbf ft)
34
®
243™