Husqvarna FC 250 2017 Owner's Manual page 90

17 SERVICE WORK ON THE ENGINE
–
Remove screw plug
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
F00090-10
–
Position oil screen
–
Position the pin wrench through the drilled hole of the screw plug in the opposite
section of the engine case.
–
Push the oil screen all the way into the engine case.
F00091-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
–
Mount and tighten oil drain plug
Guideline
Oil drain plug with magnet
120302-10
–
Remove screws
120303-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
F00092-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the housing.
–
Oil the O-ring of the oil filter cover and mount it with oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
120303-11

with oil screen

with the O-rings on a pin wrench.

with the O-ring.

with the magnet and a new seal ring.

. Remove the oil filter cover with the O-ring.

out of the oil filter housing.

.
M20x1.5 15 Nm (11.1 lbf ft)
M12x1.5 20 Nm (14.8 lbf ft)
M6 10 Nm (7.4 lbf ft)
88

.