Checking For Chain Dirt Accumulation - Husqvarna FC 250 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.34

Checking for chain dirt accumulation

Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or damaged.
H01415-11
–
Attach the hose to the fuel tank breather on the tank lid.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
H01414-11
–
Mount and tighten screws
Guideline
Remaining screws, chassis
H01413-11
–
Plug in connector
–
Remove the wash cap set and thoroughly clean the plug-in connection of the fuel
line using compressed air.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the fuel
line clogs the injection valve!
–
Lubricate the O-ring and connect plug-in connection
H01411-11
Info
Route the cable and fuel line at a safe distance from the exhaust system.
Finishing work
–
Mount the seat. (
–
Install the air filter box cover. (
–
Install the right side cover. (
–
Check the chain for coarse dirt accumulation.
» If the chain is very dirty:
–
Clean the chain. (
400678-01
p. 56)

with the rubber bushing.
M6

.
M6

for the fuel pump.
p. 46)
p. 46)
p. 50)
p. 53)
52
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)

for the fuel line.