Interface Cables; Using The Usb Interface; Using The Ethernet Interface - Fuji Xerox DocuCentre-IV 2060 Administrator's Manual

Interface Cables

Using the USB Interface

1
2
3
4
5
6
7
8
9
10

Using the Ethernet Interface

1
2
3
Downloaded From ManualsPrinter.com Manuals
When connecting the machine directly to a computer, use the USB interface. When
connecting the machine to a network, use the Ethernet interface.
The USB interface of the machine supports USB 2.0.
This section describes the installation procedures for the USB interface.
Press the power switch to the [
Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
Open the front cover.
Press the main power switch to the [
Connect the USB cable to the USB 2.0
interface connector.
Connect the other end of the USB cable to
the computer.
Press the main power switch to the [ | ] position to switch on the main power.
Close the front cover.
Press the power switch to the [ | ] position to switch on the power.
Restart the computer.
For more information on setting items, refer to "Printer Environment Settings" (P.247).
The Ethernet interface of the machine supports the following three types.
1000BASE-T
100BASE-TX
10BASE-T
Note • Gigabit Ethernet Kit (optional) is required for using 1000BASE-T.
This section describes the installation procedures for the Ethernet interface.
Press the power switch to the [
Make sure that the touch screen is blank and the <Energy Saver> button does not
light up.
Open the front cover.
] position to switch off the power.
] position to switch off the main power.
] position to switch off the power.

Interface Cables

1
19