Convection Fan - Viking RDSOE306SS Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.

Convection Fan

To access convection fan:
1. Remove unit from installation (in order to
replace the convection motor, the oven has to
be completely removed from the cabinet).
2. Remove oven door (see Door Removal).
3. Remove rear cover (see Rear Cover
Disassembly).
4. Remove convection element (see Convection
Element).
5. Remove nut securing fan blade to convection
fan motor shaft.
Convection Fan Blade
6. Remove screws securing convection fan
assembly to oven cavity.
© 2012 Viking Preferred Service
Nut
Screw
7. Disconnect wiring.
Connections
8. Remove convection fan assembly.
Convection Fan Assembly
9. Repair or replace convection fan assembly as
necessary.
10. Reverse procedure to reinstall.
Note: Removing the convection fan is a two man
operation.
51