Rear Cover Disassembly; Oven Light - Viking RDSOE306SS Service Manual

Service Diagnostics and Procedures
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.

Rear Cover Disassembly

1. Remove unit from installation.
2. Slide the unit out until rear cover is accessible.
3. Remove screws securing rear cover.
4. Remove panel.
5. Reverse to reassemble.
Note: RDDOE306SS model shown.
© 2012 Viking Preferred Service

Oven Light

CAUTION
DO NOT touch bulb with bare hands. Clean off
any signs of oil from the bulb and handle with a
soft cloth.
To access oven light:
1. Unsnap oven light cover.
2. Firmly grasp light bulb an pull out of socket.
3. Replace with new halogen bulb following
wattage and voltage rating on old halogen bulb.
4. Reinstall light cover.
1
3
2
4
47